Yealink W56H/W60B – Operation

Factory Resetting – Handset

Factory resetting a phone is when you restore a device to its original factory settings. This will delete everything that was previously on the device.

1. Press the OK button in the middle of the phone to bring up the Phone’s menu.
   
2. Using the directional buttons, navigate to Settings and press OK.
   
3. Enter System Settings by pressing 8 on the dialpad, or scrolling down (with directional buttons) and pressing OK.
   
4. Navigate to Base Reset and press OK.
   
5. Enter the PIN for your device (default is “0000”) and press Done.
   
6. The base will now factory reset and upon completion, will display “Success” (or similar) on the phone screen.
   

Factory Resetting – Base Station

1. Power off the unit by unplugging the power cord from the back (for PoE, disconnect the network cable).
2. Wait for 15 seconds.
3. With the unit unplugged, press and hold the connect button on the base station.
   
4. While still holding the connect button, plug the power (or network cable if PoE) back into the unit.
5. Wait until all three lights on the unit are showing as solid green, and release the connect button.
6. Wait approximately 5 minutes.
7. Reboot the unit by unplugging it from power for 15 seconds and plugging it back in.

Handset Registration

You can register up to 8 handsets to one W60B base station. Each handset can be registered to
4 different base stations. When the handset LCD screen prompts “Unregistered!”, long press on the base station till the registration LED indicator flashes. There are two methods to register a new handset:

Easy Registration:

1. Press the Reg soft key on the handset to register quickly.

Normal Registration:

1. Press the OK soft key on the handset, and then select Register Handset.
2. Select the desired base station and then press the OK soft key. The handset begins searching
   the base station.
3. Press the OK soft key after searching a base station successfully.
4. Enter the base station PIN (default: 0000), and then press the Done soft key to complete
   the registration.
   To register to multiple base stations, press OK to enter the main menu, and select Settings->
   Registration->Register Handset, then repeat steps 2-4.

If the handset is registered to the base station successfully, the handset LCD screen prompts
“Handset Subscribed” and “Base NO.”( the last 4 characters indicate the base station’s MAC
address).
If the handset LCD screen prompts “Searching for Base”, check that your base station is
powered on.

User Guide

For information on how to operate your Yealink W56H/W60P not referenced here, please refer to the user guide.

https://support.yealink.com/forward2download?path=ZIjHOJbWuW/DFrGTLnGypjZRKhDplusSymbolXJQ4VsYaqJZ58v5zW8/6Vg2Mi6uXiqq3toyBePyh/UgvUNYsqOzbgpZav1U/LUjkrwzrUpYh6xBz58gbdIhSNYPWLWGdeplusSymbolctsGhO91ObSSCJiIbCD77jVOOplusSymbolHOmBDw4rfWeK